Grand Prix V8-305 5.0L (1984)
Figure 3
IMPORTANT:
When reassembling a 3rd roller clutch, ensure that the lube dam is pressed into the proper depth. If the 3rd roller clutch is mated to the thrust needle
bearing instead of the washer, then:
-
press the dam to a depth of 20.72/20.92 mm (0.816/0.824") as measured from the bottom side (sprag side) of the outside race to the wide flat edge
of the dam as shown in Figure 3.
If using the thrust washer, press the dam (on models so equipped) to a depth of 20.04/20.12 mm (0.789/0.792") as measured from the bottom side (sprag
