pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Sunroof / Moonroof Track|Service and Repair|Page 16075 > < Sunroof / Moonroof Switch|Locations|Page 16071
Page 1
background image

Sunroof / Moonroof Track: Service and Repair

SUNROOF TRACK TIMING/SYNCHRONIZATION (PES)

REMOVAL PROCEDURE

1. Remove the headliner. 
2. Disconnect the electrical connector from the motor/actuator.
3. Remove the motor/actuator. 
4. Remove the screw that attaches the control module.

5. Install a pin temporarily in the holes to hold the position while installing the drive motor.
6. Remove the sunroof window. 
7. Manually slide the mechanism forward in the track until the mechanism reaches the hard stop.

8. Push the cam assembly (2) forward until the timing hole (3) in the cam is aligned with the timing hole (4) in the lifter arm (1).

9. IMPORTANT:  Both mechanisms should now be in the closed position.

Repeat this procedure for the opposite side.

INSTALLATION PROCEDURE

1. NOTE:  Refer to Fastener Notice.

Install the sunroof window. 

Tighten the screws to 4 N.m (35 lb in).

Sunroof / Moonroof Track|Service and Repair|Page 16075 > < Sunroof / Moonroof Switch|Locations|Page 16071