Grand Prix V8-5.3L (2007)
*
Tighten the bolt a second pass to 140 degrees using J 45059.
7. Remove the EN 47699 and bolt from the block and flywheel.
8. Install the transmission bellhousing bolt located at approximately the 10 o'clock position when looking from the rear of the engine.
Tighten the bolt to 75 N.m (55 lb ft).
9. Raise and properly position the frame and install the frame to body bolts.
10. Install the frame to radiator braces.
11. Install the front lower air deflector.
12. Connect the intermediate steering shaft to the steering gear.
13. Install the stabilizer shaft link lower nuts.
14. Connect the transaxle cooler lines to the transaxle.
15. Remove the engine support fixture.
16. Install the front fender splash shield.
17. Install the starter motor.
18. Install the air cleaner upper housing.
19. Install the accessory drive belt.
20. Install the engine mount strut.
21. Install the right front tire and wheel assembly.
22. Perform the crankshaft position (CKP) system variation learn procedure.