Grand Prix V8-5.3L (2007)
7. Remove the push-in retainer (2) from the inflator bracket (1).
8. Remove the screw (3) from the inflator bracket.
9. Remove the roof rail module from the vehicle.
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface. Inspect the nuts and replace if necessary.
Caution: Apply Loctite 242(R) Threadlocker US P/N 12345382 (Canadian P/N 10953489), or equivalent, on all restraint bolts/nuts before
installation. Failure to use such threadlocker correctly may result in personal injury.
Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is
securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR
system repairs.
Notice: Refer to Fastener Notice.
2. Install the inflator bracket screw (3).
Tighten the screw to 10 N.m (89 lb in).
3. Install the inflator bracket push-in retainer (2).
