Grand Prix V8-5.3L (2007)
10. If you have a roof rail module, refer to the following instructions:
*
Place the SIR deployment fixture (3) in the center of the cleared area.
*
Fill the deployment fixture with water or sand.
*
Using the proper nuts (2) and mount the roof rail module (1) to the deployment fixture (3), with the vinyl face up.
*
Adjust and secure the fixture arms (4) to the deployment fixture (3).
*
Securely tighten all fasteners that hold the side impact module (1) to the deployment fixture (3) prior to deployment.
11. Inspect J 38826 and the appropriate pigtail adapter for damage. Replace as needed.
12. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
Important: Refer to Tools Required list for the correct adapter.
13. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
15. Connect the inflator module (1) to the adapter (2) on the SIR deployment harness (3).
Important:
*
The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the immediate area that
you intend to deploy the inflator module.
*
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the
inflator module due to the force of the rapid expansion of gas inside the inflator module.
