Grand Prix V8-5.3L (2007)
4. Turn the key to the ON/RUN position. Install the ignition lock cylinder into the ignition switch.If you turned the key slightly while removing the
lock cylinder, you may have to align the white ignition switch rotor (1) with the lock cylinder (2). You can rotate the switch rotor with your finger.
5. Remove the key.
6. Position the ignition switch to the I/P trim pad.
7. NOTE: Refer to Fastener Notice.
Install the ignition switch bolts.
Tighten the bolts to 10 N.m (89 lb in).
8. Install the I/P driver knee bolster.
9. Install the I/P steering column opening filler panel.
10. Install the left I/P insulator.
11. Install the I/P accessory trim plate.
12. Install the ignition switch bezel.
13. Connect the battery ground cable.
