Grand Prix V8-5.3L (2007)
Steering Shaft: Service and Repair
Intermediate Steering Shaft Replacement
Intermediate Steering Shaft Replacement
Tools Required
J 42640 Steering Column Lock Pin
Removal Procedure
1. Raise and support the vehicle. refer to Vehicle Lifting.
2. Position the seal in order to provide access to the lower pinch bolt on the intermediate steering shaft.
3. Remove the lower pinch bolt from the power steering gear stub shaft.
Notice: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position
before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some
components during installation and result in damage to the SIR coil assembly.
Notice: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column
or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to
the coil assembly.
4. Insert J 42640 into the steering column access hole in order to lock the steering column. This will maintain the orientation.
5. Disconnect the intermediate steering shaft from the power steering gear stub shaft. Note the shaft to gear alignment for installation.
6. Lower the vehicle.