Grand Prix V8-5.3L (2007)
Differential: Service and Repair
Final Drive Replacement
Tools Required
J 42562 Axle Removal Wedge
Removal Procedure
1. Remove the case extension housing.
2. Remove the left drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement.
3. Rotate the differential carrier until the end of the output shaft can be seen and the differential pinion shaft (701) is in a horizontal position.
4. Place the J 42562 between the end of the output shaft and the differential pinion shaft.
5. Using a hammer, hit the end of the axle removal tool in order to compress the output shaft compression ring (512) and push the output shaft
through the differential side gear.
