Grand Prix V8-5.3L (2007)
Front Door Window Motor: Service and Repair
FRONT SIDE DOOR WINDOW REGULATOR MOTOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Remove the front door water deflector.
3. Raise the window far enough in order to gain access to the bolts (1, 2) that attach the window to the regulator.
4. Remove the bolts (1,2) that attach the window to the regulator.
5. Raise the window to the full up position and tape in place.
6. Disconnect the electrical connector (2) from the power window motor by pulling out on the tab (1).
7. Remove the front door window regulator.
8. Remove the window regulator and motor through the access opening in the inner panel.
9. Remove the power window motor bolts from the window regulator.
INSTALLATION PROCEDURE
1. NOTE: Refer to Fastener Notice.
Install the power window motor bolts to the window regulator.
Tighten the bolts to 6 N.m (53 lb in).
2. Install the window regulator and motor through the access opening.
