GTO V8-6.0L VIN U (2005)
Sun Visor: Procedures
SUNSHADE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the courtesy lamp fuse.
2. Unclip the sunshade assembly (1) from the sunshade support (2).
3. Remove the sunshade assembly attaching screws (3).
4. Pull the sunshade assembly away from the headliner, then disconnect the sunshade wire harness electrical connector (4).
INSTALLATION PROCEDURE
1. Position the sunshade assembly to the headliner, then connect the sunshade wire harness electrical connector (4).
2. Install the sunshade assembly attaching screws (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the sunshade retaining screws to 0.75 N.m (7 lb in).
3. Clip the sunshade assembly (1) to the sunshade support (2).
4. Install the courtesy lamp fuse.