GTO V8-6.0L VIN U (2005)
10. While holding the front of the seat cushion pad (1), pull the rear corners of the seat cushion cover (2) forward and away from the front seat cushion
pad to disengage the hook and loop strips (3).
11. Pull the front seat cover up and over the forward edge of the front seat cushion pad.
12. If required, peel back the upper cushion pad (1) to expose the passenger presence detector switch (2).
IMPORTANT: The upper pad is glued to the cushion pad along each edge. Use caution when removing the pad not to tear the side pads or the upper
cushion.
13. Carefully lift off the passenger presence detector switch and pull the wiring harness through the underside of the cushion pad.
IMPORTANT: The passenger presence detector wiring harness is glued to the seat cushion pad. Use caution when removing the harness not to
damage the harness.
INSTALLATION PROCEDURE
1. Carefully pull the wiring harness through the underside of the cushion pad.
2. Place the passenger presence detector switch in its depression in the seat cushion pad.
3. Apply new adhesive to the upper cushion.
