GTO V8-6.0L VIN U (2005)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement - Rear
Wheel Speed Sensor Replacement - Rear
Removal Procedure
1. Remove the electrical connector (2) from the connector retaining clip (3).
2. Disconnect the wheel speed sensor electrical connector (2).
3. Remove the wheel speed sensor retaining bolt and remove the wheel speed sensor (1) from the differential cover.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the wheel speed sensor (1) to the differential cover. Secure with 1 bolt.
Tighten the rear wheel speed sensor bolt to 10 Nm (88.5 inch lbs.).
2. Connect the wheel speed sensor electrical connector (2).
3. Install the wheel speed sensor electrical connector (2) into the connector retaining clip (3).
4. Perform Diagnostic System Check - Vehicle.