GTO V8-6.0L VIN U (2005)
Brake Switch (Cruise Control): Adjustments
CRUISE RELEASE SWITCH ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the left closeout panel.
3. Remove the left ventilation ducts.
4. Remove the stop lamp switch.
5. Disconnect the cruise switch electrical connector by pressing the connector locking tab while pulling on the cruise control switch connector.
6. Turn the cruise control release switch assembly counterclockwise 90 degrees and pull out of the brake pedal support.
7. Push the switch assembly (1) so the plunger is pressed and the end switch barrel is against the brake pedal (2).
8. Turn the cruise control release switch assembly (1) clockwise 90 degrees to lock in place. The distance between the brake pedal and the switch
barrel should be 0.2-1.2 mm (0.008-0.047 in).
9. Install the stop lamp switch.
10. Install the left ventilation ducts.
11. Install the left I/P lower insulator panel.
12. Connect the negative battery cable.
