GTO V8-6.0L VIN U (2005)
20. Remove the 2 TORX bolts (1, 8) and the 2 washers (2, 3) from the brake backing plate shield (4).
21. Important: Ensure the park brake adjuster anchor bracket assembly (5) remains on the shield.
Remove the 2 bolts (6, 7).
22. Use a M10 X 1.25 bottoming tap and a suitable lubricant in order to clean the threads (4, 5, 7, 8) in the control arm. Clean the threads from the
inboard side to the outboard side. Repair the threads if necessary.
23. Install 2 J-42094-7-A supports (1, 6) to the control arm, in the 2 shallowest control arm to shield bolt holes, near the caliper mounting holes.
24. Install the J-42094-7-AUS-2 (2) support to the control arm, in the deepest control arm to shield bolt hole.
25. Install the J-42094-7-AUS-1 (3) support to the control arm, in the remaining control arm to shield bolt hole.
26. Ensure the 4 supports are in the correct positions in order to attach to the flat surface of the J-42094-1-B.
