GTO V8-6.0L VIN U (2005)
INSTALLATION PROCEDURE
1. Apply a few drops of clean engine oil to the male pipe end.
CAUTION: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the
risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings
located in the female connector will swell and may prevent proper reconnection if not lubricated.
2. Push both sides of the fitting together in order to cause the retaining tabs to snap into place.
3. Once installed, pull on both sides of the fitting to make sure the connection is secure.
4. Reposition the dust cover over the quick-connect fitting.
