GTO V8-6.0L VIN U (2005)
5. Remove the two screws (1) securing the ECM to the mounting bracket
6. Remove the ECM.
Installation Procedure
1. Install the ECM to the mounting bracket.
NOTE:
-
Do not touch the connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage to
the PCM.
-
In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
2. Install the 2 screws (1) securing the ECM to the mounting bracket
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the ECM fasteners to 1-3 N.m