GTO V8-6.0L VIN U (2005)
7. Disconnect the steering wheel module connector (2).
8. Disconnect the wiring harness connectors (1 and 4).
IMPORTANT: When disconnecting connector (1) take care to avoid damage to the wiring harness.
9. Remove the steering wheel module (3).
10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Connect the wiring harness connectors (1 and 4).
CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
2. Connect the steering wheel module electrical connector (2).
3. Install the steering wheel module (3). Align the module to the 4 retaining clips on the steering wheel and press the steering wheel module toward
the steering wheel until the retaining clips lock.
IMPORTANT: Ensure the wiring harness connectors and wiring harness is not exposed or trapped between the steering wheel module and the
steering wheel hub.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
Instrument Panel Module Replacement
INFLATABLE RESTRAINT INSTRUMENT PANEL MODULE REPLACEMENT
