GTO V8-6.0L VIN U (2005)
3. Put on safety glasses.
4. Inspect the J 38826 and the EL-46850 for damage. Replace as needed.
5. Short the 2 SIR deployment harness (1) leads together using one banana plug seated into the other.
6. Connect the SIR deployment harness adapter (2) to the SIR deployment harness (1).
7. Remove the inflator module from the vehicle.
8. Place the module with the vinyl trim cover facing up and away from the surface on a work bench.
CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
9. Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the module. If possible, use a paved, outdoor location free of
activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
10. Make sure no loose or flammable objects are in the area.
11. Place the module in the space with the vinyl trim cover facing up.
12. Extend the SIR deployment harness and adapter to full length from the module.
13. Place a 12 volt minimum/2 amp minimum power source, i.e., vehicle battery, near the shorted end of the harness.
14. Connect the module (1) to the adapter (2) on the SIR deployment harness (3).
15. Firmly seat the adapter into the module connector.
16. Clear the area of people.
