GTO V8-6.0L VIN U (2005)
Brake Switch (Cruise Control): Service and Repair
CRUISE RELEASE SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the left closeout panel.
3. Remove the left ventilation ducts.
4. Remove the stop lamp switch.
5. Press the connector locking tab while pulling on the cruise control switch electrical connector (1) and remove from the switch assembly (2).
6. Turn the cruise control release switch assembly (1) counterclockwise 90 degrees and pull out of brake pedal support.
7. If required, press the locking tabs on the rear of the cruise release switch retaining clip (2) and remove.
INSTALLATION PROCEDURE
