GTO V8-6.0L VIN U (2005)
Alternator: Service and Repair
Generator Bracket Replacement
GENERATOR BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air cleaner assembly intake duct.
2. Remove the accessory drive belt idler pulley.
3. Remove the generator.
4. Remove the front generator bracket bolt and front bracket.
5. Remove the generator rear mounting bolt to the engine (2).
6. Remove the generator rear bracket.
INSTALLATION PROCEDURE
1. Install the generator rear bracket and bolt (2) to the engine.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the generator rear mounting bolt to the engine (2) to 50 N.m (37 lb ft).
2. Install the generator front bracket and bolt to the engine.
Tighten the generator bracket bolt to 50 N.m (37 lb ft).
