GTO V8-6.0L VIN U (2005)
17. Tighten the 2 nuts (2) that retain the strut to the knuckle.
Tighten the nuts to 85 Nm (63 ft. lbs.).
18. Install the front brake rotor.
19. If you replaced the hub, measure the assembled lateral runout (LRO) of the brake rotor in order to ensure optimum performance of the disc brakes.
Refer to Brake Rotor Assembled Lateral Runout (LRO) Measurement.
20. If the brake rotor assembled LRO measurement exceeds the specification, adjust the LRO to the specification.
21. Install the tire and wheel assembly.
22. Lower the vehicle onto the alignment rack in order to place the weight of the vehicle onto the tires.
23. Push down on the front bumper 3 times in order to stabilize the suspension.
24. Measure the wheel alignment.
25. If necessary, adjust the alignment to the specification. Refer to Wheel Alignment Specifications. If necessary, rotate the camber adjusting screw in
order to adjust the front camber.
26. Tighten the 2 nuts that retain the strut to the knuckle.
1. Tighten the nuts to 100 Nm (74 ft. lbs.).
2. Use the J45059 in order to tighten the nuts an additional 90 degrees.
27. Lower the vehicle.
