GTO V8-6.0L VIN U (2005)
14. Rotate the J-42094-4-A in order to press the wheel bearing into the control arm. Ensure the wheel bearing is seated properly in the control arm.
15. Remove the J-42094-8-A from the bearing.
16. Use snap ring pliers in order to install the bearing retainer to the control arm.
17. Remove the tools from the control arm.
18. Install the rear disc brake backing plate shield (4) and the park brake anchor bracket assembly (5) to the control arm.
19. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 TORX bolts (1, 8) and the 2 washers (2, 3) to the shield. Align the cut edge of the washers with the surface of the hub.
Tighten the bolts to 75 Nm (55 ft. lbs.).
20. Apply LOCTITE 242, or equivalent, to the threads of the 2 bolts (6, 7).
21. Install the 2 bolts to the anchor bracket.
Tighten the bolts to 88 Nm (65 ft. lbs.).
22. Use a bearing driver collar (4) and press plates in order to support the outside end of the hub (5) on a hydraulic press. Ensure the weight of the hub
is on the outside end of the hub and not on the wheel studs.
