GTO V8-6.0L VIN U (2005)
12. Press the constant velocity joint onto the drive shaft with the recess (4) on the inner race (3) facing the shoulder (4) on the drive shaft.
13. Install the retaining clip.
14. Pack one tube of grease into the inner side of the constant velocity joint and the boot.
15. Pack a half tube of grease into the outside of the constant velocity joint.
16. Apply a 8 mm (0.315 inch) bead of RTV to the inside of the end cap and the dust shield. Allow to cure.
17. Install the dust shield and end cap by gently tapping with a hammer and punch. Ensure the bolt holes are aligned.
18. Position the small seal retaining clamp onto the neck of the seal.
19. Important: The seal must not be dimpled, stretched or out of shape in any way.
