J2000/Sunbird V6-191 3.1L (1992)
Fig. 14 Inner Pivot Bushing Removal
Fig. 15 Inner Pivot Bushing Installation
Refer to Figs. 14 and 15, for replacement procedure.
Pinion & Valve Assembly
Fig. 22 Pinion & Valve Assembly
Removal
1.
Turn stub shaft until rack guide is equal distance from both sides of housing opening, then mark location of stub shaft notch on housing, Fig. 22.
2.
Using a suitable press, press on threaded end of pinion until it is possible to remove valve and pinion assembly from housing.
3.
Replace valve body rings if necessary.
Installation
1.
Install rack so it is centered in housing.
2.
Using valve body ring protector, tool No. J 33057 to prevent damaging valve body rings, install valve and pinion assembly.
3.
When pinion and valve assembly is fully seated, ensure notch in stub shaft and mark on housing line up, and the rack is centered in housing.
Pinion Bearing Assembly
