J2000/Sunbird V6-191 3.1L VIN T MFI (1994)
2. Master cylinder to front of dash and tighten nuts to 23 Nm (17 ft lbs).
3. Remove pedal restrictor from pushrod. Lubricate pushrod bushing on clutch pedal, then connect pushrod to clutch pedal and install retaining clip.
4. If equipped with cruise control, check switch adjustment at clutch pedal.
NOTE: If adjustment is necessary, do not exert an upward force on clutch pedal pad of more than 89 Nm (20 ft lbs) or damage to master cylinder
pushrod retaining ring may result.
5. Sound insulator and then bleed system, refer to Clutch, M/T / Service and Repair.
7. Washer bottle and electrical connection.
8. Air cleaner, mass air flow sensor and air intake duct.
9. Clamp retaining air intake duct to throttle body.
10. PCV pipe retaining clamp.
11. Mass air flow and IAT sensor leads.
12. Battery and left fender brace.
13. Positive and negative battery cables, then air intake duct to air cleaner.
