J2000/Sunbird V6-191 3.1L VIN T MFI (1994)
Inspect
^
Reservoir for air bubbles
8. Continue until air bubbles are no longer entering the reservoir.
9. Install the actuator cylinder on the transaxle
10. Install the clutch master cylinder mounting nuts
Tighten
^
Nuts evenly to 21 N.m (16 lbs. ft.).
Inspect
^
Fluid level in reservoir. Fill reservoir with Hydraulic Clutch Fluid GM P/N 12345347 or equivalent.
11. Start the engine and push the clutch to the floor. Wait ten seconds and select reverse gear. There should be no grating of gears. If so, hydraulic
system may still contain air. If this is the condition, repeat bleeding procedure.
