Montana AWD V6-3.4L VIN E (2004)
Front Bumper Cover / Fascia: Service and Repair
Fascia Replacement - Front Bumper (Pontiac)
Fascia Replacement - Front Bumper (Pontiac)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove both of the front tire and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the right and left front fender liner. Refer to Fender Liner Replacement (See: Fender/Front Fender/Front Fender Liner/Service and Repair
) in Body Front End.
4. Remove the front park/turn signal/side marker lamp. Refer to Park/Turn Signal/Side Marker Lamp Replacement in Lighting Systems.
5. Use the J 38778 to remove the push-in retainers from the upper and lower front bumper fascia.
6. Remove the front bumper fascia from the vehicle.
Installation Procedure
1. Align the front bumper to the front impact bar and to the body.
2. Install the push-in retainers to the upper and lower front bumper fascia.
3. Install the front park/turn signal/sidemarker lamp. Refer to Park/Turn Signal/Side Marker Lamp Replacement in Lighting Systems.
4. Install the right and left front fender liner. Refer to Fender Liner Replacement (See: Fender/Front Fender/Front Fender Liner/Service and Repair)
in Body Front End.
5. Install both of the front tire and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
6. Lower the vehicle.
