Montana AWD V6-3.4L VIN E (2004)
Power Sliding Door Motor: Service and Repair
Motor Clutch Replacement - PSD (With RPO Code E58)
MOTOR CLUTCH REPLACEMENT - POWER SLIDING DOOR (WITH RPO E58)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the right rear quarter lower trim panel.
3. Open the sliding door 1/3 of the way.
4. Support the bottom of the sliding door.
5. Remove the center roller bracket pin. Separate the center roller bracket, body side, from the center roller bracket, door side.
6. Position the bottom of the sliding door out at the rear in order to provide access to the center roller bracket, body side.
7. Remove the sliding door center track cover.
8. Position the sliding door center roller bracket, body side, at the front of the center roller track.
9. Release the cable tension by pushing the tensioning nut inward. Pull the rear cable in order to achieve slack.
10. Visually confirm that the cables are slack by observing that the center white dots are below the white indicator bands.
11. Lift the center roller bracket, body side, up and out from the front radius of the sliding door center track.
12. Detach the cable ends from the sliding door center roller bracket, body side.
