Montana AWD V6-3.4L VIN E (2004)
11. Position the cable guide bracket pulley to the rear pillar.
12. Install the cable guide bracket pulley bolts.
Tighten
Tighten the pulley bolts to 10 N.m (89 lb in).
13. Route the rear cable through the guide bracket pulley.
14. Slide the cable guide bracket pulley cover over the pulley.
15. Align the slot in the cable guide bracket pulley cover to the hole in the guide bracket.
16. Connect both the front and rear cable ends to the center roller bracket.
IMPORTANT: Ensure that the power sliding door cable barrels are properly installed into the sliding door center roller bracket, body side, cable
retaining fingers located on the roller bracket. Then bend the retaining fingers 90 degrees over the barrel ends.
17. Install the center roller bracket to the center roller track.
18. Position the sliding door roller bracket in front of the sliding door center track.
19. Adjust the cable tension.
20. Install the sliding door center track cover.
