Montana AWD V6-3.4L VIN E (2004)
Trunk / Liftgate Hinge: Service and Repair
Hinge Replacement - Liftgate
Removal Procedure
1. Remove the liftgate. Refer to Liftgate Replacement (See: Service and Repair/Liftgate Replacement) .
2. Remove the headliner. Refer to Headliner Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner Replacement) in
Interior Trim.
3. Use a grease pencil to mark the liftgate hinge position to the body.
4. Remove the hinge retaining nuts from the vehicle roof.
5. Remove the hinge from the vehicle.
Installation Procedure
1. Align the hinge with the marks made on the vehicle body.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the hinge retaining nuts.
Tighten the liftgate hinge stud nuts to 25 N.m (18 lb ft).
3. Install the headliner. Refer to Headliner Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner Replacement) in
Interior Trim.
4. Install the liftgate. Refer to Liftgate Replacement (See: Service and Repair/Liftgate Replacement) .
