Montana AWD V6-3.4L VIN E (2004)
Arm Rest: Service and Repair
Armrest Replacement - Front Seat
Armrest Replacement - Front Seat
Removal Procedure
1. Recline the seat back to a full upright position.
2. Remove the front seat. Refer to Seat Replacement - Bucket (See: Seats/Service and Repair/Seat Replacement - Bucket) .
3. Remove the J retainer from the bottom edge of the seat back trim cover.
4. Reach underneath the trim cover.
5. Release the C-clip from the armrest pivot shaft while pushing in on the armrest.
6. Remove the armrest from the seat.
Installation Procedure
1. Install the armrest to the seat.
Important: Ensure that you reset the C-clip (open end facing downwards) into the slotted shaft if the armrest C-clip becomes disengaged
from the slotted shaft during the removal of the armrest.
2. Push inward on the armrest in order to seat the C-clip onto the armrest pivot shaft.
3. Install the J retainer at the bottom edge of the seat back trim cover.
4. Install the front seat. Refer to Seat Replacement - Bucket (See: Seats/Service and Repair/Seat Replacement - Bucket) .
5. Return the seat back to the original position.