Montana AWD V6-3.4L VIN E (2004)
8. Assemble the brake hose bolt (1) and the NEW copper brake hose gaskets (3) to the brake hose (2).
9. Install the brake hose bolt to the brake caliper.
-
Tighten the bolt to 54 Nm (40 ft. lbs.).
10. Remove the nuts securing the rotor to the hub.
11. Install the tire and wheel.
12. Lower the vehicle.
13. Fill the master cylinder to the proper level.
14. Bleed the brake system.
15. Apply approximately 778 Nm (175 ft. lbs.) of force to the brake pedal for ten seconds.
16. Inspect the brake caliper and hydraulic brake system for brake fluid leaks.
Rear
Brake Caliper Replacement - Rear
Removal Procedure
Caution:
Refer to Brake Dust Caution in Service Precautions.
Caution:
Refer to Brake Fluid Irritant Caution.
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from
the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level,
then remove brake fluid to the midway point before proceeding.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and wheel.
5. Install two nuts to retain the rotor to the hub.
