Montana AWD V6-3.4L VIN E (2004)
Caution: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel lockup will
occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an Antilock stop.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings during the next few steps when ready.
6. Install the master cylinder brake pipes into the BPMV.
^
Tighten the fittings to 24 Nm (18 ft. lbs.).
7. Install the four wheel brake pipes on the BPMV.
^
Tighten the fittings to 24 Nm (18 ft. lbs.).
8. Reconnect the ground strap between the EBCM assembly and the chassis.
9. Connect the EBCM harness connector.
10. Push down lock tab (1) and then move sliding connector cover (2) back in home position to lock.
11. Insert red locking tab back in place.
12. Reinstall the air cleaner housing.
