Montana AWD V6-3.4L VIN E (2004)
9. Position the J21177-A over the park brake shoe (1) at the widest point.
10. Turn the adjuster on the actuator until the park brake shoe (1) just contacts the J21177-A.
11. Repeat steps eight through ten for the opposite side.
12. Install both rear brake rotors.
13. Install both rear caliper brackets.
14. Install the rear wheels and tires.
15. Adjust the parking brake by turning the nut at the equalizer (2) while spinning both rear wheels. When either rear wheel starts to drag, back off the
nut one full turn.
16. Lower the vehicle to curb height.
17. Apply the parking brake, then inspect for rotation of the rear wheels. If the rear wheels rotate during this inspection, readjust the parking brake
shoes.
18. Release the parking brake. Verify that the wheels rotate freely.
19. Lower the vehicle.
