Montana AWD V6-3.4L VIN E (2004)
Heater Hose: Service and Repair
Heater and A/C Pipe
HEATER AND AIR CONDITIONING (A/C) PIPE REPLACEMENT/REPAIR - AUXILIARY
TOOLS REQUIRED
J 41425 A/C Line Repair Kit
Do not service the rear A/C or heater lines as a complete unit.
Service the rear A/C or heater lines as a sectional repair.
You can obtain the various sections of line through GMSPO.
Use the J 41425 when any of the following actions damage the rear A/C or heater lines:
-
Rub-through
-
Collision damage
-
Leakage in the system
IMPORTANT:When you section the rear A/C or heater lines, ensure that the correct minimum length remains in the straight part of the line on both
sides of the splice.
Follow the Straight Line Repair procedure in order to repair line damage of line.
Minimum Tube Length Required Table
Follow the Line Sectioning Repair procedure in order to repair any damage in a bend area. Do not repair the rear A/C or heater lines in a bend area,
replace the lines. Maintaining the original line shape will prevent vibrations and rub-through.
Straight Line Repair
1. Recover the refrigerant, if repairing the A/C lines.
2. Drain the coolant, if repairing the heater lines.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Obtain a length of replacement line to make the repair.
6. Use a tubing cutter in order to cut and remove the section of damaged line.
7. Use a tubing cutter in order to cut the replacement line to length.
IMPORTANT:The length of the replacement line must be the same as the section being replaced.
8. Use the cleaning pad from the J 41425 in order to clean any burrs or grease from the line ends. Be sure to clean at least 19 mm (0.75 in) from the
