Montana AWD V6-3.4L VIN E (2004)
1. Install the auxiliary air temperature actuator to the HVAC module assembly.
2. Install the auxiliary air temperature actuator retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to.....1.6 N.m (14 lb in).
3. Connect the auxiliary air temperature actuator electrical connector.
4. Install the left lower quarter trim panel.
Air Temperature Actuator Replacement - Left
AIR TEMPERATURE ACTUATOR REPLACEMENT - LEFT
REMOVAL PROCEDURE
1. Remove the knee bolster.
2. Set the HVAC controls to the vent mode to position the defroster door lever.
IMPORTANT:The HVAC controls must be set to the vent mode to position the defroster door lever for access to the air temperature actuator.
3. Remove the left hand temperature door lever bolt (3) from the HVAC module.
4. Disconnect and remove the left hand temperature door lever spring (2).
5. Disconnect and remove the left hand temperature door lever (1) from the left hand temperature door.
