Montana AWD V6-3.4L VIN E (2004)
Marker Lamp: Service and Repair
Tail Lamp Assembly, Backup, Sidemarker, Stop, Turn Signal Bulb
TAIL LAMP ASSEMBLY AND /OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT
REMOVAL PROCEDURE
1. Open the liftgate.
2. Remove the screws from the tail lamp.
3. Pull the tail lamp from the body.
4. Disconnect the electrical connector from the tail lamp.
5. Press the tabs to release the circuit board from the tail lamp.
6. Remove the circuit board from the tail lamp.
7. Remove the required bulbs from the sockets.
INSTALLATION PROCEDURE
