Montana AWD V6-3.4L VIN E (2004)
1. Install the air intake duct to the MAF sensor.
2. Install the air intake duct to the throttle body and the air cleaner cover to the air cleaner assembly.
3. Latch the air cleaner cover clips (1).
4. Reconnect the MAF sensor electrical connector (2).
5. Reconnect the vent tube to the air intake duct.
6. Install the IAT sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Tighten the 2 intake air duct clamps (1).
Tighten
Tighten the intake air duct clamps to 2 N.m (18 lb in).