Montana AWD V6-3.4L VIN E (2004)
1. Install the retractor side seat belt to the vehicle.
2. Install the retractor to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Use the J 29843-9 in order to install the bolt securing the retractor to the D-Pillar.
Tighten
Tighten the bolt to 43 N.m (32 lb ft).
4. Install the drivers side rear quarter trim with RPO-C34 rear AC only.
5. Slide the belt webbing through the slotted trim cover. Then snap the plastic trim cover to the D-Pillar (3) trim panel.
6. Install the lower seat belt anchor (4) to the floor.
7. Use the J 29843-9 in order to install the bolt (5) securing the lower seat belt anchor (4) to the floor.
Tighten
Tighten the bolt to 43 N.m (32 lb ft).
8. Install the upper seat belt anchor (1) to the D-Pillar (3).
9. Use the J 29843-9 in order to install the bolt (1) securing the upper seat belt anchor to the D-Pillar (3).
Tighten
Tighten the bolt to 43 N.m (32 lb ft).
10. Install the cover (2) to the upper seat belt anchor.
