Montana AWD V6-3.4L VIN E (2004)
seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if
their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt
pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.
TOOLS REQUIRED
-
J 39401-BSIR Deployment Fixture
-
J 38826 SIR Deployment Harness
-
An appropriate pigtail adaptor
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the seat belt pretensioner from the vehicle.
5. When carrying a seat belt pretensioner to the deployment area, keep the open end of the seat belt pretensioner pointed away from the body.
6. Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the seat belt pretensioner. If possible, use a paved, outdoor location
free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
8. Place the J 39401-B SIR Deployment Fixture in the center of the cleared area.
9. Fill the fixture plastic reservoir with water or sand.
