Montana AWD V6-3.4L VIN E (2004)
Impact Sensor: Service and Repair
Front
INFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 1.
2. Remove the connector-position assurance (CPA) from the electrical connector on the front end sensor.
3. Disconnect the front end sensor electrical connector (2) from the front end sensor.
4. Remove the 2 integral bolts that retain the front end sensor to the frame front crossmember.
5. Remove the front end sensor from the vehicle.
INSTALLATION PROCEDURE
1. Install the front end sensor to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the 2 integral bolts that retain the front end sensor to the frame front crossmember.
Tighten
Tighten the bolts to 8 N.m (71 lb in).
3. Connect the sensor electrical connector (2) to the front end sensor.
4. Install the CPA to the sensor electrical connector.
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1.
