Montana AWD V6-3.4L VIN E (2004)
Ride Height Sensor: Technical Service Bulletins
Automatic Suspension - Revised Level Control Sensor Svc.
Bulletin No.: 05-03-15-001
Date: November 28, 2005
SERVICE MANUAL UPDATE
Subject:
New Automatic Level Control Sensor Link Ball Stud Replacement (IRS) Procedure, Automatic Level Control Sensor Link Replacement (IRS)
Procedure, Automatic Level Control Sensor Replacement (IRS) Procedure
Models:
2002-2005 Chevrolet Venture
2002-2004 Oldsmobile Silhouette
2002-2005 Pontiac Montana
This bulletin is being issued to add the Automatic Level Control Sensor Link Ball Stud Replacement (IRS) procedure, Automatic Level Control Sensor
Link Replacement (IRS) procedure and Automatic Level Control Sensor Replacement (IRS) procedure in the Automatic Level Control sub-section of the
Service Manual.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
Automatic Level Control Sensor Link Ball Stud Replacement (IRS)
Removal Procedure
1.
Remove the ELC/TRAILER fuse.
2.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Important:
When removing the link, do NOT bend or break the sensor arm.
3.
Remove the automatic level control sensor link (1) from the ball stud.
4.
Remove the ball stud (2) from the control arm.
Installation Procedure
