Montana AWD V6-3.4L VIN E (2004)
5.
Remove the automatic level control height sensor from the vehicle.
6.
Remove the automatic level control height sensor link from the sensor arm
Installation Procedure
1.
Install the automatic level control height sensor link onto the sensor arm.
2.
Install the automatic level control height sensor to the vehicle.
Note:
Refer to Fastener Notice in Cautions and Notices.
3.
Install the height sensor bracket bolts (1).
Tighten
Tighten the height sensor bracket bolts to 85 N.m (63 lb ft)
4.
Install the automatic level control height link to the tie rod ball stud. Refer to Automatic Level Control Sensor Link Replacement.
5.
Install the automatic level control height sensor electrical connector (1).
6.
Lower the vehicle.
Disclaimer