Montana AWD V6-3.4L VIN E (2004)
1. Install the inlet hose.
2. Install the inlet hose to the hose retainer.
3. Install the inlet hose to the power steering pump.
4. Install the inlet hose to the power steering gear cooler pipe.
5. Install the right side engine splash shield.
6. Lower the vehicle.
7. Install the drive belt.
8. Fill the power steering fluid reservoir.
9. Bleed the power steering system. Refer to Bleeding the Power Steering System. See: Power Steering Bleeding/Service and Repair/Bleeding the
Power Steering System
