Montana AWD V6-3.4L VIN E (2004)
1.
Position the ELC sensor link (1) to the ball studs on the sensor and control arm.
2.
Press the ELC sensor link ends onto the ball studs until fully seated.
3.
Lower the vehicle.
Automatic Level Control Sensor Replacement (IRS)
Removal Procedure
Important:
When replacing the height sensor a diagnostic system check must be performed
1.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2.
Remove the automatic level control height sensor electrical connector (1).
3.
Remove the automatic level control height sensor link from the ball stud. Refer to Automatic Level Control Sensor Link Replacement.
4.
Remove the automatic level control height sensor bracket bolts (1).
