Montana AWD V6-3.4L VIN E (2004)
2. Install the strut upper nuts.
^
Tighten the strut upper nuts to 30 Nm (22 lb ft).
3. Install the strut lower bolts and nuts.
Important: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
^
The fastener and its counterpart are clean and free from rust.
^
The fastener develops 3 Nm (27 lb in) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
4. Align the strut to the mark on the knuckle.
^
Tighten the strut lower nuts to 112 Nm (83 lb ft).
5. Install the wiper module.
6. Install the tire and wheel.
7. Lower the vehicle.
8. Inspect the alignment.
Strut, Strut Component and/or Spring Replacement
Strut, Strut Component and/or Spring Replacement
^
Tools Required
-
J 42991 Strut Rod Nut Socket
-
J 45400 Strut Spring Compressor
Disassembly Procedure
