Montana AWD V6-3.4L VIN E (2004)
1. Connect the wheel speed sensor electrical connector (2).
2. Install the wheel bearing/hub.
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the NEW wheel bearing/hub bolts.
^
Tighten the NEW wheel bearing/hub bolts to 80 Nm (59 lb ft).
4. Install the brake drum.
5. Install the tire and wheel.
6. Lower the vehicle.
Wheel Bearing/Hub Replacement - Rear (Disc and AWD)
Wheel Bearing/Hub Replacement - Rear (Disc and AWD)
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the knuckle.
