Montana AWD V6-3.4L VIN E (2004)
1. Install the servo spring.
2. Install the servo piston assembly.
3. Install the forward servo cover O-ring.
4. Install the forward servo cover.
Notice: Refer to Fastener Notice in Service and Precautions.
5. Install the forward band servo cover bolts.
Tighten the bolts to 12 Nm (106 inch lbs.).
6. Remove the drain pan from under the forward servo cover.
Important: Ensure that the power steering cooler line does not become trapped or damaged during this step.
7. Use the utility stand in order to raise the frame rear.
8. Install the NEW frame bolts.
9. Adjust the utility straps as necessary in order to align the powertrain mounts with the frame.
10. Install the transaxle mount nuts. Refer to Automatic Transmission Mount Replacement.
11. Install the engine mount nuts. Refer to Engine Mount Replacement.
12. Install the power steering gear to the frame. Refer to Power Steering Gear Replacement.
13. Install the power steering gear heat shield.
14. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement.
15. Lower the vehicle.
16. Remove the engine support fixture. Refer to Engine Support Fixture.
17. Adjust the fluid level. Refer to the following information:
^
Transmission Fluid Checking Procedure
^
Fluid and Lubricant Recommendations.
^
Capacities - Approximate Fluid.
