Montana AWD V6-3.4L VIN E (2004)
8. Remove the PNP switch bolts.
9. Remove the PNP switch.
Installation Procedure
1. Verify that the shift shaft is in the Neutral position.
Important: DO NOT ROTATE A NEW PNP SWITCH. A new PNP switch is produced in the Neutral position. If the bolt holes do not align
with the holes in the transaxle, verify that the transmission is in Neutral. Adjust the PNP switch if the new switch has been rotated and the pin is
broken or if using an old PNP switch. Refer to PNP Switch Adjustment.
2. Align the flats of the shift shaft to the flats in the PNP switch.
3. Install the PNP switch to the transaxle.
Notice: Refer to Fastener Notice in Service and Precautions.
4. Install the PNP switch bolts.
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Install the automatic transaxle range selector lever. Refer to Automatic Transmission Range Selector Cable Lever Replacement.
