Montana AWD V6-3.4L VIN E (2004)
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the extension housing assembly to the J 44755 (2) using M8 x 1.25 bolts (1).
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Install the flange nut (1) onto the driven shaft.
^
Tighten the flange nut to 250 Nm (185 ft. lbs.).
7. Remove the extension housing assembly from the J 44755.
8. Measure the rotating torque of the driven shaft in both directions.
^
The driven shaft and bearings should have a rotating torque of 1.5 Nm (13 inch lbs.).
